Stereo Tool 7.70 Full Version ~ Borneo Deejay [BDJ™]

Stereo Tool Full adalah sebuah pluggin yang dibuat khusus untuk media player winamp dan berfungsi untuk melakukan konfigurasi dan mengubah frekuensi suara dan musik di winamp tersebut. Jika anda merasa suara yang dihasilkan dari winamp anda kurang bagus, maka pluggin Stereo Tool Full ini adalah aplikasi yang sangat tepat untuk anda. Anda dapat mengoptimalkan suara yang dihasilkan dari winamp tersebut dengan melakukan beberapa konfigurasi pada winamp tersebut menggunakan pluggin Stereo Tool Full ini.

Disini kami membagikan Stereo Tool ini lengkap dengan keygen yang dapat anda gunakan untuk melakukan aktifasi pada pluggin ini dengan gratis. Jadi dengan kata lain anda akan mendapatkan Stereo Tool Full Version dan menikmati semua fitur premium dari pluggin ini. Jadi tunggu apalagi, segera anda download dan instal pluggin Stereo Tool Full ini sekarang juga.

Features Of Stereo Tool Full Version

Declipper. A unique filter only found in one other processor. It finds and restores clipping (distortion caused by too loud input levels) which is present in most music from the last two decades. See the Perfect Declipper site for more info.
Hiss removal filter. Stereo Tool contains a powerful hiss reduction filter that has almost no effect on the rest of the sound. Especially useful when playing older songs or when a lot of volume compression is used.
FM hiss removal filter. This is useful when the input signal comes from an FM transmitter, for example when re-broadcasting the sound from an FM station.
Automatic Gain Control (AGC). This AGC keeps all the sounds below a defined level. Different from many traditional processors, the AGC in Stereo Tool is not peak level based but acts on how loud something sounds to human hearing.
10-band multiband compressor / limiter / clipper. If one song contains a lot of bass, and the next contains a lot of treble, this filter can make them sound equal. Older or bad quality recordings can be made to sound closer to the sound of modern CD’s, which generally sounds much better on a wide range of playback equipment.
Phasing error (AZIMUTH) correction filter. Old tape recordings and many cheap CDs often suffer from severe phasing errors. These phasing errors can make listening very unpleasant, and when the phasing error changes over time the sound can seem to “float” around you. It can also cause severe artifacts when converting the sound to mono or when playing it on a surround system. This filter automatically detects and repairs such errors. For FM transmissions this can reduce multipath distortion.
Stereo Booster. This filter increases the existing stereo sound, unless it was already very loud, which makes the sound much fuller. It can be configured to not alter the total sound content.
Stereo to mono conversion. Converts stereo to mono without removing sounds that normally cancel out each other. So the mono sound still sounds just as full and powerful as the original stereo sound.
Bass booster. This filter increases the bass level without increasing the maximum amplitude of the bass.
Final limiter. The Stereo Tool Final Limiter can transparantly remove short spikes in the signal – so with nearly no effect on the sound.
Distortion masking Loudness filter. This filter can make sounds up to 12 dB louder, without causing higher amplitude peaks in the signal, with little effect on the sound. Especially useful for radio stations that want to sound loud.
Lowpass filter. The extremely steep phase linear lowpass filter can be used to cut off frequencies that cannot be broadcast (streaming audio, FM transmitter, AM transmitter).